Skip to content

Section Elevation

(Available in Platinum)

Default UI Menu: Architecture/ Section/Elevation

Ribbon UI Menu:

img

There are three tools used to create Section-Elevations.

Horizontal

img

Default UI Menu: Architecture/ Section/Elevation / Horizontal

Ribbon UI Menu:

img

Create a horizontal section.

  1. Create a 3D element. Now use section line tool that cross the pertinent 3D elements.
  2. Select horizontal section tool. Right click to open the local menu. Select either 2D Section /Elevation or 3D Section /Elevation.

Alternatively, you can also select 2D Section /Elevation or 3D Section /Elevation from the inspector bar.

  1. Select the Section line.
  2. Select the pertinent 3D elements.
  3. Select finish from the local menu or in the inspector bar. You will then have the section and will be prompted to select section position. Click in the drawing to place the section.

You can edit the size, orientation and position of the section line using the edit tool.

Section Line

img

Default UI Menu: Architecture/ Section/Elevation / Section Line

Ribbon UI Menu:

img

Create a section line.

  1. Define the segment start point.
  2. Define the end point, or specify the length and angle in the inspector bar.

img

Vertical

img

Default UI Menu: Architecture/ Section/Elevation / Vertical

Ribbon UI Menu:

img

Create a vertical section.

  1. Create a 3D element. Now use the section line tool to cross the pertinent 3D elements.
  2. img
  3. Select vertical section tool. Right click to open the local menu. Select either 2D Section /Elevation or 3D Section /Elevation.

Alternatively, you can also select 2D Section /Elevation or 3D Section /Elevation in the inspector bar.

img

  1. Select the Section line.
  2. Select the pertinent 3D elements.
  3. Select finish from local menu or in the inspector bar. You will then have the section and will be prompted to select section position. Click in the drawing to place the section.

img

You can edit the size, orientation and position of the section line using edit tool.